CAS No. 25764-13-0

Chemical Identifiers

Linear Formula YN
Pubchem CID 117630
MDL Number N/A
EC No. 247-248-8
IUPAC Name azanylidyneyttrium
Beilstein/Reaxys No. N/A
SMILES N#[Y]
InchI Identifier InChI=1S/N.Y
InchI Key AJXBBNUQVRZRCZ-UHFFFAOYSA-N

Health & Safety Information

Signal Word N/A
Hazard Statements N/A
Hazard Codes N/A
Risk Codes N/A
Safety Statements N/A
Transport Information N/A

View and Print SDS

SAFETY DATA SHEET

Date Accessed: 12/06/2021
Date Revised: 05/15/2015

SECTION 1. IDENTIFICATION

Product Identifiers: All applicable American Elements product codes for CAS #25764-13-0

Relevant identified uses of the substance: Scientific research and development

Supplier details:
American Elements
10884 Weyburn Ave.
Los Angeles, CA 90024
Tel: +1 310-208-0551
Fax: +1 310-208-0351

Emergency telephone number:
Domestic, North America +1 800-424-9300
International +1 703-527-3887


SECTION 2. HAZARDS IDENTIFICATION

This substance is not classified as dangerous according to Directive 67/548/EEC.
Physical hazards
Not classified as a physical hazard.
Health hazards
Not classified as a health hazard.
Environmental hazards
Not classified as an environmental hazard.
No hazards resulting from the material as supplied.


SECTION 3. COMPOSITION/INFORMATION ON INGREDIENTS

Components: Yttrium nitride
Cas-No.: 25764-13-0
EC-No.: 247-248-8


SECTION 4. FIRST AID MEASURES

Inhalation
If breathing is difficult, remove to fresh air and keep at rest in a position comfortable for breathing.
Call a physician if symptoms develop or persist.
Skin contact
Wash off with soap and water. Get medical attention if irritation develops and persists.
Eye contact
Flush eyes with water as a precaution. Get medical attention if irritation develops and persists.
Ingestion
Rinse mouth. If ingestion of a large amount does occur, call a poison control centre immediately.
General advice
If you feel unwell, seek medical advice (show the label where possible).


SECTION 5. FIREFIGHTING MEASURES

Suitable extinguishing media
Water.
Fire fighting equipment/instructions
In the event of fire, cool tanks with water spray.
Specific methods
Cool containers exposed to flames with water until well after the fire is out.


SECTION 6. ACCIDENTAL RELEASE MEASURES

Containment procedures
Stop the flow of material, if this is without risk.
Personal precautions
Local authorities should be advised if significant spillages cannot be contained. Keep unnecessary personnel away. Wear appropriate protective equipment and clothing during clean-up.
Environmental precautions
Prevent further leakage or spillage if safe to do so.
Methods for cleaning up
Small Dry Spills: With clean shovel place material into clean, dry container and cover loosely; move
containers from spill area. Following product recovery, flush area with water. For waste disposal,
see section 13 of the SDS.


SECTION 7. HANDLING AND STORAGE

Handling
Avoid prolonged exposure. Use care in handling/storage.
Storage
Store in original tightly closed container. Store in accordance with
local/regional/national/international regulation.


SECTION 8. EXPOSURE CONTROLS/PERSONAL PROTECTION

Biological limit values
No biological exposure limits noted for the ingredient(s).
Recommended monitoring procedures
Additional exposure data
Not available.
Engineering measures
Good general ventilation (typically 10 air changes per hour) should be used. Ventilation rates should be matched to conditions. If applicable, use process enclosures, local exhaust ventilation, or other engineering controls to maintain airborne levels below recommended exposure limits. If exposure limits have not been established, maintain airborne levels to an acceptable level.
Personal protective equipment
Respiratory protection
When workers are facing concentrations above the exposure limit they must use appropriate
certified respirators.
Hand protection
Not normally needed.
Eye protection
Not normally needed.
Skin and body protection
Normal work clothing (long sleeved shirts and long pants) is recommended.
Hygiene measures
Handle in accordance with good industrial hygiene and safety practices.


SECTION 9. PHYSICAL AND CHEMICAL PROPERTIES

Appearance
Physical state: Solid.
Form: Solid.
Colour: Not available.
Odor: Not available.
Odor threshold: Not available.
pH: Not available.
Boiling point: Not available.
Flash point: Not available.
Flammability limits in air, upper, % by volume: Not available.
Flammability limits in air, lower, % by volume: Not available.
Vapor pressure: < 0,0000001 kPa at 25 °C
Relative density: Not available.
Solubility (water): Not available.
Partition coefficient (n-octanol/water): Not available.
Viscosity: Not available.
Vapor density: Not available.
Evaporation rate: Not available.
Melting point/freezing point: Not available.
Auto-ignition temperature: Not available.
VOC: Not available.
Molecular formula: NY


SECTION 10. STABILITY AND REACTIVITY

Conditions to avoid
None under normal conditions.
Hazardous decomposition products
No hazardous decomposition products are known.
Stability
Material is stable under normal conditions.


SECTION 11. TOXICOLOGICAL INFORMATION

Routes of exposure
Inhalation.
Chronic toxicity
Prolonged inhalation may be harmful.
Carcinogenicity
Not classifiable as to carcinogenicity to humans.
Mutagenicity
No data available to indicate product or any components present at greater than 0.1% are
mutagenic or genotoxic.
Reproductivity
Not classified.
Epidemiology
No epidemiological data is available for this product.


SECTION 12. ECOLOGICAL INFORMATION

Aquatic Toxicity: Low
Persistent Bioaccumulation Toxicity: No
Very Persistent, Very Bioaccumulative: No
Notes: N/A


SECTION 13. DISPOSAL CONSIDERATIONS

Disposal instructions
Collect and reclaim or dispose in sealed containers at licensed waste disposal site.
Waste from residues / unused products
Dispose of in accordance with local regulations.
Contaminated packaging
Empty containers should be taken to an approved waste handling site for recycling or disposal.


SECTION 14. TRANSPORT INFORMATION

Hazardous:
Not hazardous for transportation.
Hazard Class: N/A
Packing Group: N/A
UN Number: N/A
Proper Shipping Name: N/A


SECTION 15. REGULATORY INFORMATION

Regulatory information
This Safety Data Sheet complies with the requirements of Regulation (EC) No 1907/2006. The
product does not need to be labelled in accordance with EC directives or respective national laws.
Labeling
Contains
Yttrium nitride
EC number
247-248-8
R-phrase(s)
None.
S-phrase(s)
None.


16. OTHER INFORMATION

Safety Data Sheet according to Regulation (EC) No. 1907/2006 (REACH). The above information is believed to be correct but does not purport to be all inclusive and shall be used only as a guide. The information in this document is based on the present state of our knowledge and is applicable to the product with regard to appropriate safety precautions. It does not represent any guarantee of the properties of the product. American Elements shall not be held liable for any damage resulting from handling or from contact with the above product. See reverse side of invoice or packing slip for additional terms and conditions of sale. COPYRIGHT 1997-2016 AMERICAN ELEMENTS. LICENSED GRANTED TO MAKE UNLIMITED PAPER COPIES FOR INTERNAL USE ONLY.