SECTION 1. IDENTIFICATION
Product Identifiers: All applicable American Elements product codes for CAS #86233-74-1
Relevant identified uses of the substance: Scientific research and development
Supplier details:
American Elements
10884 Weyburn Ave.
Los Angeles, CA 90024
Tel: +1 310-208-0551
Fax: +1 310-208-0351
Emergency telephone number:
Domestic, North America +1 800-424-9300
International +1 703-527-3887
SECTION 2. HAZARDS IDENTIFICATION
Classification
This chemical is considered hazardous by the 2012 OSHA Hazard Communication Standard (29 CFR 1910.1200)
Skin Corrosion/irritation:
Category 2
Serious Eye Damage/Eye Irritation:
Category 2
Specific target organ toxicity (single exposure):
Category 3
Target Organs:
Respiratory system.
Label Elements
Signal Word: Warning
Pictogram
GHS07
Hazard Statements:
Causes skin irritation
Causes serious eye irritation
May cause respiratory irritation
Precautionary Statements
Prevention:
Wash face, hands and any exposed skin thoroughly after handling
Wear protective gloves/protective clothing/eye protection/face protection
Avoid breathing dust/fume/gas/mist/vapors/spray
Use only outdoors or in a well-ventilated area
Inhalation:
IF INHALED: Remove victim to fresh air and keep at rest in a position comfortable for breathing
Call a POISON CENTER or doctor/physician if you feel unwell
Skin:
IF ON SKIN: Wash with plenty of soap and water
If skin irritation occurs: Get medical advice/attention
Take off contaminated clothing and wash before reuse
Eyes:
IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing
If eye irritation persists: Get medical advice/attention
Storage:
Store in a well-ventilated place. Keep container tightly closed
Store locked up
Disposal:
Dispose of contents/container to an approved waste disposal plant
Hazards not otherwise classified (HNOC):
None identified
SECTION 3. COMPOSITION/INFORMATION ON INGREDIENTS
Component:
Copper(I) hexafluoro-2,4-pentanedionate
1,5-cyclooctadiene complex
CAS-No:
86233-74-1
Weight:
< 100%
SECTION 4. FIRST AID MEASURES
General Advice:
If symptoms persist, call a physician.
Eye Contact: Rinse immediately with plenty of water, also under the eyelids, for at least 15 minutes. Get medical attention.
Skin Contact:
Wash off immediately with plenty of water for at least 15 minutes. If skin irritation persists, call a physician.
Inhalation:
Move to fresh air. If not breathing, give artificial respiration. Get medical attention if
symptoms occur.
Notes to Physician:
Treat symptomatically
Ingestion:
Clean mouth with water and drink afterwards plenty of water. Get medical attention if
symptoms occur.
Most important symptoms and effects:
None reasonably foreseeable.
SECTION 5. FIREFIGHTING MEASURES
Unsuitable Extinguishing Media: No information available
Flash Point: No information available
Method: No information available
Autoignition Temperature: No information available
Explosion Limits
Upper: No data available
Lower: No data available
Sensitivity to Mechanical Impact: No information available
Sensitivity to Static Discharge: No information available
Specific Hazards Arising from the Chemical:
Keep product and empty container away from heat and sources of ignition.
Hazardous Combustion Products:
None known
Protective Equipment and Precautions for Firefighters:
As in any fire, wear self-contained breathing apparatus pressure-demand, MSHA/NIOSH (approved or equivalent) and full protective gear.
NFPA
Health: 2
Flammability: 1
Instability: 0
Physical Hazards: -
SECTION 6. ACCIDENTAL RELEASE MEASURES
Personal Precautions:
Ensure adequate ventilation. Use personal protective equipment. Avoid dust formation.
Environmental Precautions:
Should not be released into the environment. See Section 12 for additional ecological information.
Methods for Containment and Clean Up:
Keep in suitable, closed containers for disposal. Sweep up or vacuum up spillage and collect in suitable container for disposal.
SECTION 7. HANDLING AND STORAGE
Handling:
Wear personal protective equipment. Ensure adequate ventilation. Do not get in eyes, on skin, or on clothing. Avoid ingestion and inhalation. Avoid dust formation.
Storage:
Keep containers tightly closed in a dry, cool and well-ventilated place.
SECTION 8. EXPOSURE CONTROLS/PERSONAL PROTECTION
Exposure Guidelines
This product does not contain any hazardous materials with occupational exposure limitsestablished by the region specific regulatory bodies.
Engineering Measures:
Ensure that eyewash stations and safety showers are close to the workstation location.
Personal Protective Equipment
Eye/face Protection:
Wear appropriate protective eyeglasses or chemical safety goggles as described by OSHA's eye and face protection regulations in 29 CFR 1910.133 or European Standard EN166.
Skin and body protection:
Long sleeved clothing.
Respiratory Protection:
Follow the OSHA respirator regulations found in 29 CFR 1910.134 or European Standard EN 149. Use a NIOSH/MSHA or European Standard EN 149 approved respirator if exposure limits are exceeded or if irritation or other symptoms are experienced.
Hygiene Measures:
Handle in accordance with good industrial hygiene and safety practice.
SECTION 9. PHYSICAL AND CHEMICAL PROPERTIES
Physical State: Solid
Appearance: Yellow
Odor: Odorless
Odor Threshold: No information available
pH: No information available
Melting Point/Range: 93 - 100 °C / 199.4 - 212 °F
Boiling Point/Range: 60 °C / 140 °F
Flash Point: No information available
Evaporation Rate: Not applicable
Flammability (solid,gas): No information available
Flammability or explosive limits
Upper: No data available
Lower: No data available
Vapor Pressure: No information available
Vapor Density: Not applicable
Specific Gravity: No information available
Solubility: No information available
Partition coefficient; n-octanol/water: No data available
Autoignition Temperature: No information available
Decomposition Temperature: No information available
Viscosity: Not applicable
SECTION 10. STABILITY AND REACTIVITY
Reactive Hazard:
None known, based on information available
Stability:
Stable under normal conditions.
Conditions to Avoid:
Incompatible products.
Incompatible Materials:
Strong oxidizing agents
Hazardous Decomposition Products:
None under normal use conditions
Hazardous Polymerization:
Hazardous polymerization does not occur.
Hazardous Reactions:
None under normal processing.
SECTION 11. TOXICOLOGICAL INFORMATION
Acute Toxicity
Product Information:
Component Information:
Toxicologically Synergistic: No information available
Products:
Delayed and immediate effects as well as chronic effects from short and long-term exposure
Irritation: No information available
Sensitization: No information available
Carcinogenicity:
Component: Copper(I) hexafluoro-2,4-pentanedionate 1,5-cyclooctadiene complex
CAS-No: 86233-74-1
IARC: Not listed
NTP: Not listed
ACGIH: Not listed
OSHA: Not listed
Mexico: Not listed
Mutagenic Effects: No information available
Reproductive Effects: No information available.
Developmental Effects: No information available.
Teratogenicity: No information available.
STOT - single exposure: Respiratory system
STOT - repeated exposure: None known
Aspiration hazard: No information available
Symptoms / effects,both acute and delayed: No information available
Endocrine Disruptor Information: No information available
Other Adverse Effects: The toxicological properties have not been fully investigated.
SECTION 12. ECOLOGICAL INFORMATION
Ecotoxicity
Do not empty into drains.
Persistence and Degradability: Persistence is unlikely based on information available.
Bioaccumulation/ Accumulation: No information available.
Mobility: Will likely be mobile in the environment due to its volatility.
SECTION 13. DISPOSAL CONSIDERATIONS
Waste Disposal Methods:
Chemical waste generators must determine whether a discarded chemical is classified as a hazardous waste. Chemical waste generators must also consult local, regional, and
national hazardous waste regulations to ensure complete and accurate classification.
SECTION 14. TRANSPORT INFORMATION
DOT: Not regulated
TDG: Not regulated
IATA: Not regulated
IMDG/IMO: Not regulated
SECTION 15. REGULATORY INFORMATION
All of the components in the product are on the following Inventory lists:
X = listed
International Inventories
E - Indicates a substance that is the subject of a Section 5(e) Consent order under TSCA.
F - Indicates a substance that is the subject of a Section 5(f) Rule under TSCA.
N - Indicates a polymeric substance containing no free-radical initiator in its inventory name but is considered to cover the designated polymer made with any free-radical initiator regardless of the amount used.
P - Indicates a commenced PMN substance
R - Indicates a substance that is the subject of a Section 6 risk management rule under TSCA.
S - Indicates a substance that is identified in a proposed or final Significant New Use Rule
T - Indicates a substance that is the subject of a Section 4 test rule under TSCA.
XU - Indicates a substance exempt from reporting under the Inventory Update Rule, i.e. Partial Updating of the TSCA Inventory Data Base
Production and Site Reports (40 CFR 710(B).
Y1 - Indicates an exempt polymer that has a number-average molecular weight of 1,000 or greater.
Y2 - Indicates an exempt polymer that is a polyester and is made only from reactants included in a specified list of low concern reactants that comprises one of the eligibility criteria for the exemption rule.
U.S. Federal Regulations
TSCA 12(b): Not applicable
SARA 313: Not applicable
SARA 311/312: Hazard Categories See section 2 for more information
CWA (Clean Water Act): Not applicable
Clean Air Act: Not applicable
OSHA: Not applicable
CERCLA: Not applicable
California Proposition 65: This product does not contain any Proposition 65 chemicals
U.S. State Right-to-Know Regulations: Not applicable
U.S. Department of Transportation
Reportable Quantity (RQ): N
DOT Marine Pollutant: N
DOT Severe Marine Pollutant: N
U.S. Department of Homeland Security:
This product does not contain any DHS chemicals
Other International Regulations:
Mexico - Grade No information available
16. OTHER INFORMATION
Safety Data Sheet according to Regulation (EC) No. 1907/2006 (REACH). The above information is believed to be correct but does not purport to be all inclusive and shall be used only as a guide. The information in this document is based on the present state of our knowledge and is applicable to the product with regard to appropriate safety precautions. It does not represent any guarantee of the properties of the product. American Elements shall not be held liable for any damage resulting from handling or from contact with the above product. See reverse side of invoice or packing slip for additional terms and conditions of sale. COPYRIGHT 1997-2022 AMERICAN ELEMENTS. LICENSED GRANTED TO MAKE UNLIMITED PAPER COPIES FOR INTERNAL USE ONLY.
